Fife Csp-01 Manual Jun 2026

: Features a knob-adjusted panel for manual control and digital I/O for status and interlocks. Operational Features

Hold the web material in the sensor gap. Press and hold the "Calibrate" button on the sensor amplifier (or the CSP-01 board if equipped) for 5 seconds. The LED will flash twice, indicating the "web present" value is stored. Fife Csp-01 Manual

: Real-time visual representation of the web position relative to the sensor. : Features a knob-adjusted panel for manual control

Refer to your specific system schematic, as pin configurations can vary based on the controller model. Calibration Procedure The LED will flash twice, indicating the "web

: National and local safety regulations regarding machinery and environmental protection must be followed during installation. Maintenance and Troubleshooting

Use shielded twisted-pair cables to prevent EMI from nearby motors.

: If the controller overreacts, the "Gain" may be set too high. If it's sluggish, the Gain may need to be increased.