The Siruba L818FM1, a popular model in the industrial sewing machine lineup, has been a reliable choice for many textile manufacturers and hobbyists alike. However, like any complex machinery, it is not immune to errors and issues. This review aims to provide a comprehensive list of errors encountered with the Siruba L818FM1 in 2021, along with potential solutions and insights from users and technicians.
These errors often stem from your electrical environment rather than the machine itself. siruba+l818fm1+error+list+2021
| Error Code | Message | Possible Cause | User Action | |------------|---------|----------------|--------------| | | Motor overload | Thread tangled, material jam | Remove fabric/thread, restart | | E-03 | Needle position sensor error | Sensor dirty/misaligned | Clean sensor, recalibrate | | E-05 | Foot lift solenoid failure | Solenoid stuck or disconnected | Check wiring, replace solenoid | | E-07 | Thread trimmer error | Knife stuck, magnet switch fault | Clean trimmer mechanism | | E-08 | Low voltage (under 180V) | Power supply unstable | Check mains voltage | | E-10 | Main motor encoder fault | Encoder disconnected/damaged | Replace encoder board | | E-12 | Control panel communication lost | Cable loose or panel faulty | Reconnect panel cable | | E-15 | Overcurrent | Short in motor or driver | Cycle power; if persists, service | The Siruba L818FM1, a popular model in the